Used Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991 For Sale

Asking Price
Contact Me for Price
Stock:
Only 1 Available on the Marketplace!
Seller:
Member ID 53872 - avatar

Peter

Member since: April 2015

More listings by this seller

Make an Offer Ask the Seller a Question
Name:
Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991
Listing Reference:
609730
Price:
Contact Me for Price
Location:
IL, USA
Age:
Unknown
Description:

Serial No. 2322 New - 1991 SPECIFICATIONS: Floor Area Requirements 6'6" L x 4'6" W x 5' H Work Tray 40" H GENERAL INFORMATION: The Model 2H-36 Spindle Type Finishing Machine is composed of the following major components: (1) The Rotating Tube that carries the finishing media, (2) The Two Spindle Supporting Heads, (3) The Two Spindle Assemblies, (4) The Structural Base, and (5) The Electrical Controls. The rotating tub measures 36" wide in diameter by 18-1/2" in depth and is fabricated of 3/16" steel plate of all welded construction with the tub bottom further reinfored with structural channels. A 3" wide section of the tub at the bottom periphery is perforated and covered on the O.D. with fine mesh screen to allow continual drainage of liquids from the tubs interior. The tub is mounted on the vertical output shaft of a heavy duty gear reducer driven by a 15 HP variable speed drive unit for 460 volt, 3 phase, 60 cycle operation with a tub speed of up to 1200 SFM (Surface Feet Per Minute). The spindle support heads are fabricated of heavy section structural steel members and are rigidly gusseted to provide an integral rigid unit capable of maintaining positive alignment of the spindle with respect to the rotating tub. Raising and lowering of spindles is accomplished with an air cylinder. Spindles are adjustable through a 20 degree range fore and aft of the flow of material in the rotating tub and from 0 degrees to 20 degrees from perpendicular to the outer periphery of the tub together with 3-1/2" horizontal extension. EQUIPPED WITH: Texas Instruments Series 305-O5B Programmable Controller ATC Spindle Counters (2) Each Forward & Reverse Control for Variable Tub Speed with Digital Tachometer *Preliminary Specifications Subject to Verification.

Used equipment can sell very quickly. Contact the seller asap to discuss this Automated Finishing,No.2H-36, 2-Spdl, Rotating Tub,Slurry Deburring Machine 1991.

Make an Offer Ask the Seller a Question
Asking Price
Contact Me for Price
Stock:
Only 1 Available on the Marketplace!
Seller:
Member ID 53872 - avatar

Peter

Member since: April 2015

More listings by this seller

Make an Offer Ask the Seller a Question
Make the Seller an Offer

Make the Seller an Offer

* required field

$ (USD)

Sending an offer to the seller does not constitute a legally binding agreement to purchase the equipment. However, please only make an offer if you are seriously interested.

Your offer will be emailed to the seller immediately. We will email you their reply as soon as we receive it.

Ask the Seller a Question

Ask the Seller a Question

* required field

Your question will be sent to the seller immediately and we will email you as soon as they reply.