Bryant 1460

Listing description

Bryant 1460 Internal Grinder

Specifications:
Swing: 60"
Stroke: 16"
Maximum Traverse Stroke: 21"
Work Head Speed: 15, 25, 35, 50 RPM
Work Head Swivel Adjustment: Up to 90 Degrees
Max. Including angle which can be ground w/Full 60" Sw: 60 Degrees
Cross Adjustment of Work Head (Forward): 16"
Cross Adjustment of Work Head (Rear): 14"
Wheel Head Cross Travel: 8"
Work Head Motor (4-Speed Gear Reduction): 2.5 - 7.5 HP
Grinding Saddle Motor (1750 RPM, 220/440 V, 3/60): 25 HP
Hydraulic Pump Motor: 2 HP
Estimated Net Weight: 24,000 Lbs
Workhead can be adjust length-wise so that minimum:
distance from work head spindle flange to forward:
position of wheel slide: 21" min to 44" max.
Equipped With:
60" "T" Slotted Face Plate (3" Thick)
48" 6-Jaw Morton Independent Chuck With Soft Solid Reversible Top Jaws
9" Thru-Hole In Work Head Spindle
Internal Grinding Spindle ( 16" Quill Length With Installed
11" Length Quill Extension Total: 28"
Adjustable Trip Dogs For Grinding Spindle Saddle Manual/Auto Cycles
Single Point (Hand Type) Rear Adjustable Table Dresser
Separate Hydraulic Unit
Separate Electric Control Panel
Separate (Baffle Type) Coolant Tank & Pump
Extra Chuck Jaws ( Soft & Hard )
Automatic Way Lubrication
Factory Installed Work head Chuck Guard (Hinge Type For Quick & Easy Access)

Comments:
Very Good (As Purchased From Running Service At U.S.A. End User Facility)
This Machine is a Very Rare Extra Large Capacity Horizontal Design
Hydraulic I.D. Grinder And Shows Low Use On All Square Block Way
and Way Bearing Surfaces
Machine Will Be Available For Inspection Under Power At Our Dryden, Michigan
Warehouse Upon Cycling Which Includes Replacing All Fluids, Filters,
(Wipers, Screws, Nuts, Bearings If Needed) Coolant Splash Guarding,
Retractable & Collapsible Traveling Hydraulic Cylinder Guards For Wheel
Infeeds/Retract
Machine Will Go Through Our In-House Processing Departments!!!
Machine Will Be Sanded, Primed, Filled Then Custom Painted With Ppg Ditzler
High Gloss Acrylic Enamel Paint (7b Gray/Or Color Of Choice)
Ppg Delstar Slow ( Hot ) Reducer & Ppg Delthane Hardener.
Machine Paint Will Never Peel, Chip, Crack Or Wear as Our Process Using the Highest Quality Materials Will Be Applied to Properly Prepared Surfaces of this Extra Large (Extremely Rare) Machine Tool

This equipment is located in US