Used Ex-Cell-O High Speed Attachment For Sale

Asking Price
Contact Me for Price
Stock:
Only 1 Available on the Marketplace!
Seller:

Art L.

Member since: July 2011

More listings by this seller

Contact the Seller
Name:
EX-CELL-O High Speed Attachment
Listing Reference:
602190
Price:
Contact Me for Price
Location:
NJ, USA
Age:
Unknown
Description:

6 RPM 6'' LENGTH Ex-Cell-O High Speed Attachment GRINDING SPINDLE, In Wood Box;Reference Number: 138538a;EX-Cell-O High Speed Surface Grinding Attachment;Slots and other surfaces which do not permit;the use of a wheel of large diameter can be;ground with this attachment. The attachment;spindle is mounted on super-precision ball;bearings and is belt-driven from a pulley;mounted on the spindle of the machine.;The attachment body fits onto the machine spindle;sleeve in place of the wheel guard and can be used;in practically any angular position around the;machine spindle. With the attachment spindle in;the lowest position, the maximum vertical distance;between center of the attachment spindle and top;of machine table is 12" with the handwheel on the;upright, this distance is reduced to 10".;To install the attachment, remove the grinding;wheel and wheel guard from the machine and slip;the attachment bracket onto the spindle sleeve.;then, attach the driving pulley and the belt.;next place the guard over the pulley and fasten.;finally bring the attachment spindle to the;desired angular position around the machine;spindle, turn the large knurled shoulder;behind the belt guard to adjust the belt tension;and clamp both of these adjustments by tightening;the rear hollow-head screw at the top of the;attachment body. Make sure that the other hollow-;head screw is also tight before grinding.;The spindle is grease-packed and requires no;lubrication.;A variety of wheel arbors and grinding wheels;are available at extra cost. The exacting;limits and fine finish demanded of this;equipment require extreme accuracy in the taper;fit between spindle and wheel arbor. Therefore;we strongly recommend that all wheel arbors be;furnished by the manufacturer to assure the ut-;most in precision and finish.;In changing wheels or arbors,a spring-loaded;plunger in the front of the attachment body;above the spindle can be pushed in to hold;the spindle from rotating. Make sure that the;spindle hole and arbor shank are perfectly;clean before inserting an arbor, and seat the;arbor firmly in the spindle. Keep in mind;that the arbors have a left-hand thread.;Never put a cold arbor in a warm spindle, for;when the arbor expands (or the spindle cools;and contracts), the taper fit will be so tight;that removal of the arbor will be difficult.

Used equipment can sell very quickly. Contact the seller asap to discuss this Ex-Cell-O High Speed Attachment.

Contact the Seller
Asking Price
Contact Me for Price
Stock:
Only 1 Available on the Marketplace!
Seller:

Art L.

Member since: July 2011

More listings by this seller

Contact the Seller
Contact the Seller

Contact the Seller

* required field

Your question will be sent to the seller immediately and we will email you as soon as they reply.