Gleason Hypoid Spiral Bevel Ge

Listing description

Suitable For The Lapping Of Hardened Hypoid Gears
And Pinions Up To 17” (432Mm) Diameter, Operating At A
90-Degree Shaft Angle

The Machine Is Being Offered In First Class Condition
Throughout And Having Been Professionally Rebuilt By
Gleason Service Specialists.

Equipment / Features:
Automatic Lapping Cycle
Automatic Backlash Control
Standard Splash Guard Arrangement
Hydraulic Chucking Attachment
Dynamometer-Type Brake For Load Simulation
Full Complement Of Electrics (Motors/Controls)

Principal Specifications:
Distance From Center Of Gear Spindle

To Nose Of Pinion Spindle (Maximum)
10-1/2"
(267Mm)
Distance From Center Of Gear Spindle

To Nose Of Pinion Spindle (Minimum)
6-1/4"
(169Mm)
Distance From Center Of Gear Spindle

To Nose Of Gear Spindle (Maximum)
10-3/4"
(273Mm)

Distance From Center Of Gear Spindle

To Nose Of Gear Spindle (Minimum)
5"
(172Mm)
Offset Of Gear Spindle Above Or Below

Center Of Pinion Spindle (Maximum)
3"
(76Mm)
Diameter Of Gear (Maximum Nominal) 17"
(432Mm)
Diameter Of Gear (Maximum Actual W/Extended Guard
22”
(559Mm)
Maximum Set-Over:

Vertical

.040" (1.0Mm)

Horizontal

.040" (1.0Mm)

Backlash

.150"
(3.8Mm)
Diameter Of Spindle Taper Hole At Large End

3-29/32"
(100Mm)
Spindle Taper Per Foot

39/64"
(15Mm)
Depth Of Spindle Taper

6"
(152Mm)
Diameter Of Hole Through Spindle 3-1/2”
(89Mm)
Hydraulic Pump
3/4 Hp, 1800 Rpm
Drive Spindle Speed
600 & 1200 Rpm
Main Motor (Two-Speed)
2-1/2 Hp, 900 Rpm
Lapping Compound Pump Motor
1/2 Hp, 1800 Rpm
Oscillating Drive Motor
1/15 Hp, 0 To 1725 Rpm
Floor Space
64" X 90" (163X229Cm)
Machine Overall Height:

Lapping Guard Closed
59-1/2" (151Cm)

Lapping Guard Open
81-1/4" (206Cm)
Net Weight
11,000 Lbs (5000 Kg)

This equipment is located in US