OKUMA VTM200-Yb

Listing description

Used Okuma Vertical Machining Centres:
Machine ordered new in 2012 but not commissioned until 2015. Only 56 hours NC running time. Will suit new buyer. Some tooling included.

Located Western Australia. Seller will assist with preparation for shipment.

Options fitted:

Local power source 415V, 50Hz, 3 phase
One Touch IGF-D kit
CE Mark
60 ATC
4,000rpm milling spindle
BT50 Big Plus taper
Independent pallet chuck 2000mm (incl. hard jaws, 1 set 4)
Soft jaws for above, 2 sets
Collision Avoidance
Chip conveyor, hinge type side (900mm high)
Full cover enclosure
Thru spindle coolant, 1.5mpa
ATS (touch setter A&M)
Helical cutting
Oil skimmer, screw type
B axis indexing, 0.001 deg. With 120 deg. Indexing angle (both 0.001 and 5 deg. available)
Absoscale XYZB
Spindle around coolant 4 nozzles, 0.75kw pump
In machine coolant flusher .73kw pump
Additional pump for above .73kw
In process work gauging (Renishaw)
Tooling kit consisting of:
OD toolholder type I-32, 4sets
OD toolholder type II-32, 4 sets
ID toolholder base H50, 4 sets
Boring bar sleeve 32-H50, 2 sets
Additional toolholder base H50, 2 sets
Additional toolholder base H50U for u-drill
Coolant pump, medium pressure for turning tool holder, 2.2kw in lieu of std .37kw
Thru spindle air during spindle rotation
B axis slope machining function
Spindle dead slow machining function
Thread phase matching
Threading slide hold
Spindle variable speed threading
Signal tower
Portable pulse handle
Z axis automatic zero offset by touch sensor
C axis automatic zero offset by touch sensor
Y axis gauging
Long tool option 600mm for ID
Heavy tool option 40kg
Lifting hooks

This equipment is located in AU