110 Ton Geka Hydracrop Model 110A, New 2006, 6 X 6 X 1/2" Cap., Misc. Tooling

Listing description

specifications

equipped with

manufacturer - geka
model - hydracrop 110a
age - 2006
with the following capacities in mild steel:
angle shear:
"non-deform cut" with no material loss
angles square - 6" x 6" x 1/2"
angles on 45 degree mitre (leg in) - 3" x 3" x 5/16"
bar shear:
round bars - 2"
square bars - 2"
channels up to 6" 8.2 lb.
plate shear:
"non-deform cut" with no material loss
flat bar - 24" x 5/8" or 16" x 3/4" or 12" x 1"
blade length - 24"
punch:
capacity (tons) - 120
punching capacity - 1-1/4" thru 1" or 1-1/2" thru 3/4"
throat depth - 12"
quick change punch holder
full stroke or jog mode
up to 4" round hole or any shape that will fit into a 4" round
within tonnage capacity of machine offered as optional
accessory
note: minimum inside punch distance between centerline of hole and inside of leg is 1-5/8"
notcher:
thickness - 1/2"
depth - 3-1/2"
width - 2"
other capacities as detailed in the catalogue
standard equipment:
section shear blades for angles with patented non-deform cutting
action with capability of cutting equal and unequal leg angles
at both 90 degree and 45 degree (leg in only)
bar shear blades for 3" 4.1 pound and 4" 5.4 pound channel and
blades for round and square bar with openings for 1-3/16", 1",
3/4" and 9/16" round bar and 1-3/16", 1" and 9/16" square bar
flat bar blades (non-deform)
rectangular coper (triangular notcher optional)
two-cylinder operation with two remote foot pedals and with hydraulics
which will allow simultaneous operation (independently controlled)
of punch and shearing stations (both cylinders) to the total
operating tonnage of machine
quick-change punch holder, keyed for shaped tooling
starter set of punches and dies: round punches: 5/16", 7/16", 9/16", 5/8",
11/16", 3/4", 13/16", 7/8", 15/16", 1-1/16".
each die is 1/32" larger than the punch.
bottom style #50 and top stlye #80
support and mitre table for plate shear
3/60/220/440 motor and controls. low voltage at the controls

This equipment is located in US