Asymtek X-1010 With Dispense Jet Dj-2100

Listing description

DispenseJet DJ-2100 Jet
Non-Contact Jetting Technology for Surface Mount Adhesive Applications
Nordson ASYMTEK’s DispenseJet DJ-2100 jet is a non-contact, drop-on-demand valve providing fast fluid dispensing. The jet can deliver up to 100 dots per second. For electronics assembly requiring speed, dot consistency, and tight process control, the jet is ideal.
Non-contact jetting eliminates Z-axis motion between dots, significantly increasing speed. Jetting eliminates the need for a mechanical needle standoff (foot). Problems disappear: no expensive needles that wear out, no worrying about touching the board with a footed needle, no change to dot size due to variations on PCBs, and no expense and problems associated with underboard support. Cost of ownership is reduced.
The jet “flies” over the substrate at dispense gaps between 0.5 and 3.5 mm (0.02 and 0.14 in.). Dispense cycles of 12 to 15 milliseconds per dot offer improved throughputs over systems that have longer valve-on times and z-axis motion. The jet goes faster and provides better shot size accuracy.
Features

Accurately jets surface mount adhesive dots for a wide range of component sizes
Eliminates Z-axis motion during dispensing and virtually eliminates height sensing
Tolerates greater variations in PCB planarity
Provides threefold improvement in consistency over needle-based dispensing systems
Adaptable for use from prototype to high-volume, in-line production
Dot diameter down to 0.33 mm (0.013 in.) for 0402 components

Specifications
Specifications: DJ-2100 Jet
Service

Offline cleaning: 60 minutes every 1 to 2 weeks

Cleaning fluids for SMA:

Acetone or MEK-based solvent recommended

Do not use alcohol, water, or water-based solvents

Valve

Operating voltage: 24 VDC

Weight: 380 g (without syringe)

Syringe: 5, 10 or 30 cc

Compatibility: All Nordson ASYMTEK dispensing platforms

Electrical

Solenoid: 24 VDC, 5.4 Watts

Heater: 8.5 Watts

Pressures

Air solenoid pressure:

6.5 Bar (100 psi) max.

4.8 Bar (70 psi) min.

Fluid pressure: 0.3-2 Bar (5-30 psi)

Nozzle

Orifice diameter: 0.102-0.406 mm (0.004-0.016 in.)

Fluids

Fluid typically used in jetting applications: High-speed dispensable surface mount adhesives (SMA)

Model Number Component Size Seat Size Nozzle Selection (Typical)
DJ-2111 0402 (1005) or larger 0.4 mm (0.015 in.) 0.102 and 0.127 mm (0.004 and 0.005 in.)
DJ-2112 0603 (1608) or larger 0.75 mm (0.030 in.) 0.127 and 1.152 mm (0.005 and 0.006 in.)
DJ-2114 0805 (2012) or larger 1.5 mm (0.060 in.) 0.152, 0.200, 0.254, 0.330, 0.406 mm (0.006, 0.008, 0.010, 0.013, 0.016 in.)

This equipment is located in US