Balliu CF 1500/PS laser cutting machine

Listing description

Type: CF 1500 / PS
Parameters: 18 mm, 1500 x 3000 mm
Manufacturer: Balliu
Year of production: 2005
Location: Czech Republic
Description: Laser BALLIU CF 1500 / PS, 3.5 kW, year 2005, in operation under power, possible inspection, regularly serviced.
It is a CO2 laser with linear motors and uses the SPAB Rofin Sinar laser resonator.
Advantages of this laser source:
Cheap traffic
Low demands on rare gases such as Helium and Argon
The machine only needs dehumidified frozen air to operate.
It still has its own Donaldson freezer and therefore does not need 5.0 nitrogen for operation.
Black sheets are cut with oxygen 4.0 and higher, stainless steel sheets with nitrogen 4.0 and higher.
It has a resonator of 3,500 W, which means that it cuts black sheet metal up to 18 mm and stainless steel up to 8 mm.
It has Siemens linear motors, so it hardly requires maintenance and does not wear out mechanically, it has no screws or combs.
The cost per hour of cutting was always around CZK 800 per hour of operation.
They were able to keep the machine themselves in operation, the resonator is a patented device and an authorized service was performed once a year.
The resonator is after GO, the replacement of the cathode, which develops the beam, so it should last about 6 years of operation
The machine is in operation, offer without transport and installation. The machine is a compact, welded frame poured with polymeric concrete, it can be transported on a jumbo height of 60 cm above the road.
Installation by a manufacturer's technician takes a maximum of one week.
Technical parameters:
Sheet format: 3000 x 1500 mm
Laser power: 3500 W
Control system: Simens Sinumeric 840 D
Resonator power: Rofin Sinar 3,500 W
It burns black sheet metal up to 18 mm and stainless steel up to 8 mm
Siemens linear motors
Two interchangeable pallets
Machine weight: approx. 20 tons

This equipment is located in CZ