Brandt KDF-650C

Listing description

This machine has low hours. The current facility is not running the bander at this time.
Manufacturer specs (to be confirmed)
Although the machine is capable of running thicker panels, the pre-mill cutter heads on this machine are only 42 mm work height.
Universal automatic magazine for strip and coil feeding.
Large coil table
Quick melt granulate glue application system with 12-minute heat up time.
Quick change glue tank
Strengthened precutter for cutting PVC
Double motor end trim unit with straight and chamfer capability. Chamfer up to 15 degrees. Program controlled indexing from straight to bevel end trimming.
Fine trimming with servo motor program controlled indexing.
Contour trimmung unit
Scraping unit for rigid PVC edges. Program controlled indexing.
Buffing Unit
Electronic frequency changer for all trimming motors.
Joint triming unit Pretrim of the piece, 2-motors, vertical spindle adjustment, horizontal positioning
End trim station
Fine trim unit
Contour trim unit
Scraping unit with knives
Top and Bottom buffing unit
Premill
Corner Round
Edgeband thickness 0.4-12 mm
Edgeband height 12-60 mm
Panel Length min 160 mm
Panel width min 65 mm
Panel thickness 8 - 55 mm
Feed Speed 2-Speeds 16 m/min and 11 m/min
Feed motor 3 HP
Joint trim unit 3 HP
End trim unit (2) 1/2 HP
Fine trim unit 3/4 HP
Profile trim unit (2) 1/2 HP
Machine length 19'
Machine width 6'
Approx wieight 5,000 lbs

This equipment is located in US