Brandt KDF760

Listing description

Exceptionally well mantained machine.

Edge capacity: 0.4 - 15 mm (5/8");

Panel thickness: 8mm (5/16") - 60mm (2-3/8");

Min. panel length 160 mm (6-3/8") and min. width 65 mm (2-3/8") ;

line control (NO limit switches) for workstation function.

Adjustments on major stations are fully automated.

Pressure beam height adjustment for all work stations via digital height indicator.

PC-20 Program Control; with 12" Industrial PC screen 256 MB RAM, 1 Gb Flash card, with USB Port & remote diagnostic link.

Signal infeed light to insure proper spacing between panels.

Two (2) Motor Pre-mill unit;

Four roller pressure zone with motorized program control indexing;

Two (2) 3 HP motors (12,000 RPM) with straight and chamfer capability;

Program controlled indexing from straight to bevel.

Rotation for climb cutting & conventional machining.

Quick heat-up glue system,(approx. 10 minutes) w/hopper feeder & w/glue tank for maintenance & quick glue color change.

Glue temperature indicator for both the glue pot and glue roller with LED thermostat and automatic temperature reduction if the machine is idle for 15 minutes or more.

The glue applicator roller is also reversable and retractable from the fence line.

Automatic magazine for strip & coil (Large coil table 800 mm diameter to accommodate large coils of 3 mm PVC) stock, 3 mm PVC guillotine, (1) drive plus (3) secondary rollers "pneumatically controlled" pressure sections.

Variable Feed speed 36 - 65 FPM (3 HP feed motor).

Two (2) End trim (1/2 HP - 12,000 RPM motors), chamfers 0° - 15° via programmable controller

Top & bottom flush/radius trim, bevels 0° - 15° (3/4 HP - 12,000 RPM motor), with insert knives for 3 mm PVC radius.

Two (2) Motor Contour trimming station (1/2 HP - 12,000 RPM each motor) for corner rounding for front & trailing corners on the fly.

Top & bottom scraping for 3 mm PVC radius, pneumatically controlled indexing system; Top & bottom flat/glue scrape.

Top & bottom oscillating buffing (0.25 HP - 2,800 motors).

Corner rounding station operates at 16 MPM (52 FPM).

Complete with: Operator control panel w/PLC (Programmable Logic Control) keypad & LED readouts.

End trim, flush trim & fine trim stations have HF motors w/electronic brakes.

This equipment is located in US