Gildemeister CTX 310

Listing description

Working area
Max swing over bed..................... 500 mm (19.684 in)
Swing over X-slide..................... 375 mm (14.764 in)
Bar capacity........................... 51 mm (2 in)
Clamping chuck diameter................ 210 mm (8.26 in)
Clamping chuck diameter backspindle.... 165 mm (6.49 in)
Transverse stroke...................... 202 mm (7.952 in)
Longitudinal stroke.................... 450 mm (17.716 in)
Y-axis stroke.......................... +/- 40 mm (1.574 in)

Feed drive
Rapid traverse X/Z axes................ 24/30 m/min (787/1181 ipm)
Rapid traverse Z2/Y axis............... 30/10 m/min (1181/394 ipm)

Headstock (left/right)
Spindle nose (plain flange)............ 140 h5/145h5mm
Inside diameter front bearing.......... 100/90 mm 3.93/3.54 in
Spindle bore diameter.................. 69/44 mm 2.69/1.73 in

Main drive
Rating AC main drive (100% ED)......... 16 kW (21.4 HP)
Torque (100% ED)....................... 153 Nm 114 lb.ft.
Speed range............................ 20 - 6000 rpm

Backspindle
AC drive power (100% ED)............... 7.5 kW 10 HP
Torque (100% ED)....................... 48 Nm 35.3 lb.ft.
Speed range............................ 20 - 6000 rpm

Tool turret
Number of tool stations................ 12
Tool reception......................... VDI 3425
cylinder shaft diameter................ 30 mm (1.181 in)
Indexing time.......................... 30° 0,2 sec.
Tool turret............................ with Siemens/Heidenhain controls
Number of driven tools................. 12
Drive power (40% ED)................... 9 KW (12 HP)
Torque (40%)........................... 20 Nm (14.8 ft lb)
Max speed.............................. 4500 min-1
C-axes................................. main spindle / backspindle
Speed range............................ 0 - 200 min-1

Dimensions:
Machine L x W x H...................... 4000 x 1563 x 1730 mm
Net weight............................. 4500 kg (9920 lb)

Equipped with:
- HEIDENHAIN Plus iT with DINPlus
- SAUTER Turret - VDI 30
- All turret stations have live driven tool capability / C-axis
- SMW AUTOBLOK hydraulic 8" chuck on main spindle
- SMW AUTOBLOK hydrualic 6" chuck on sub spindle
- Lift up Chip Conveyor
- CSA electrical safety approved (see sticker in picture)
- counter spindle
- C axis
- Y axis
- tool drive
- partial hollow clamping device
- chip conveyor
- Tool preseter
- 1 GB on hard disk
- RS232C, Ethernet via TCP / IP, USB

This equipment is located in US