Hardinge Dsm-59 Second Operation Lathes

Listing description

hardinge second operation lathe,
model: dsm 59 new: 1991

specifications:
spindle capacity with:
-round 5c collets ..................... 1-1/16"
-hexagon 5c collets ................... 7/8"
-square 5c collets .................... 3/4"
-step chucks .......................... 1-1/16" to 6"
-jaw chucks ........................... 5"
jaw chucks through spindle ............ 1-5/32"
spindle nose .......................... hardinge taper
length of bed ......................... 36"
swing over bed ........................ 9"
travel of double tool cross slide ..... 3-3/4"
travel of turret slide ................ 4"
diameter of turret holes .............. 3/4"
variable spindle speed range .......... 230 to 3,500 r.p.m.

equipped with:
hardinge pre-loaded ball bearing spindle construction
hardinge ball bearing lever collet closer for type 5c collets
hexagon turret
double tool cross slide
toolblocks
push button control for variable speed
self-contained coolant system with 1/10 h.p. pump motor
3/4 - 3/8 horse power two-speed main drive motor
230 volt operation

hardinge 8' pneumatic bar feed available at additional cost .

This equipment is located in US