Homag Kal 210/7/A20/S2 Edgebander

Listing description

HOMAG KAL 210/7/A20/S2 … Edgebander with Pre-Milling & Corner Rounding (4) Motor:
Working Capacity:
Edge thickness, coiled stock min/max, 0.3 – 3 mm (0.012. – 0.112″), straight edges, min/max. 0.4 – 20 mm (0.016 – 0.788″), panel thickness min/max. 12 – 60 mm
(0.472 – 2.362″).
Equipped with:
• Pre-Milling Station: Two vertical jointing spindles, KW 3.0 x 2 (HP 4.0 x 2) – 150 Hz, 9,000 RPM Motors; equipped with panel blow off device and SIKO digital counters for adjustments.
• Panel Pre-Heat Unit: Quartz lamp for heating substrate edge before glue application.
• Edge Magazine Combination: Strip processing and (2) – coil vertical magazine for quick coil changeover.
• Gluing System A 20: EVA (Hot Melt), Quick Melt hopper feeder & roller applicator (reversible).
• Pressure Section “C”: Servo controlled with (1) Large 150 mm dia. driven & (6) idle rollers; automatic servo adjusting pressure zone through program for varying edge thicknesses.Workstations:

• End Trimming Unit HL 84: KW 0.8 x 2 (HP 1.0 x 2) – 200 Hz, 12,000 RPM Motor ea. to cut excess edge on the front & back of the panel; pneumatic adjusting from chamfer to straight snip.
• Rough/Pre-Trimming Unit: Top & bottom, KW 1.5 x 2 (HP 2.0 x 2) – 12,000 RPM ea. motor. Height adjustment with the top pressure-beam and swiveling range +/- 1°.
• Profile Trimming / Corner Rounding “FF 12” Unit: Equipped with (4) motors for fine or profile trimming upper and lower edge, as well as trimming around the front & rear edge. KW 0.4 x 4 (HP 0.54 x 4) motor ea.
• .2.2 Kw (3.0 HP) Grooving Unit, 90 deg. horizontal/vertical with jump control
• Profile Scraping Unit PN 10: Top & bottom for thick PVC/ABS, pneumatically activated
• Flat Glue Scraper Unit: Top & bottom to remove potential glue squeeze-out.
• Buffing Unit: Top & bottom edge polishing.Complete With:

This equipment is located in CA