IMA COMBIMA/K

Listing description

Squaring and edgebanding machine single sided: Edges: coil edges up to 3 mm, strips
Panels: Min length: 250 mm

Min. width: 250 mm

Min/max. thickness: 10 tot 40 mm
Equipment:

Twin chain track in the squaring part

Chain track projection towards top pressures ca. 1,30 m.

Centerdistance between the dogs ca. 500 mm

Lateral alignment device with pneumatics

Lateral fence with motorised adjustment

Tiltable infeed rollers

Squaring part with:

Jump shaper 2,2/3,3 kW, Siko readout

Twin hogger, each with motor 3/4,4 kW, pneumatic positionning with 4-fold revolver

Edging part:

IR pre-heating of the panel edge

Magazine for strips and 6-fold coils

Hotmelt unit with pre-melter

Lateral pressure rollers, 1 driven, 4 non-driven rollers

End trims, 2 motors 0,4 kW, straight and chamfer

Rough trimming,
2 motors 1 kW, Siko readout

Fine trimming, 2 motors 0,15 kW, tilting,
siko read-out

Radius trimming unit, 2 motors 0,4 kW, tilting, siko read-out

Contour trimming unit bottom, 2 motors 0,15 kW (pneumatic exclusion)

Contour trimming unit top, 2 motors 0,15 kW (pneumatic exclusion)

Radiusscrapers

Flat scrapers

Shaper horizontal with tracing, motor 3 kW

Shaper horizontal with tracing, motor 3 kW

Shaper horizontal with tracing, motor 3 kW

Free space for hot air blowers

Buffing unit with oscillation

2e Buffing unit with oscillation

This equipment is located in BE