Komatsu GPM 200F2-3 Tool grinding machine

Listing description

KOMATSU GPM 200F2-3 CNC crankshaft milling machine built in 2002 in Japan for machining crankshafts with a maximum length of 700 mm. A working head with a handle is mounted on the machine bed. The chuck has a centering triple jaw in a cast steel housing, which acts with a clamping force of 80 kN.

Clamping movements in the machine tool holder for KOMATSU GPM 200F2-3 crankshafts
1. The crankshaft is loaded on the support locks in the holders,
2. The fangs approach the centerline of the handle on both sides,
3. The crankshaft is pushed against the side support washer,
4. It is checked whether the part is well pressed (checking the seating of the part),
5. The triple jaws finally come closer to clamp the part with its main trunnion and collar.

Stable machining when cutting a detail by reducing vibrations is ensured by a steady rest installed in the machine. The machining center works in six axes (X1, X2, Y1, Y2, Z1, Z2) with maximum feeds of +/- 172.5 mm (for X1 and X2 axes), +/- 95 mm (for Y1 and Y2 axes) and + / - 450 mm (for Z1 and Z2 axes). Rapid feeds in the X, Y, Z axes are respectively 12040 mm / min, 6700 mm / min and 14400 mm / min. The axes are equipped with a SIEMENS 1FT6 actuator with an Absolute brake and are computer controlled by a SIEMENS Sinumerik 840D CNC controller. The machine has two 37 kW spindles, rotating at a speed of 188 rpm. The total weight of the crankshaft machining center is 26,000 kg.

Characteristics of the CNC machining center for KOMATSU GPM 200F2-3 crankshafts

- CNC control: SIEMENS Sinumerik 840D
- number of controlled axes: 6
- maximum length of the detail: 700 mm
- minimum eccentric diameter: 210 mm
- minimum diameter of the main journal: ƒ 50 mm
- height of the canine: 1280 mm
- maximum feed in axes:
X1: +/- 172.5 mm (tool tip 95 mm)
X2: +/- 172.5 mm (tool tip 95 mm)
Y1: +/- 95 mm
Y2: +/- 95 mm
Z1: +/- 450 mm
Z2: +/- 450 mm
- maximum rapid feed in the axes:
X: 12040 mm / min
Y: 6700 mm / min
Z: 14,400 mm / min
- X, Y, Z axis actuator: SIEMENS 1FT6 with Absolute brake
- number of spindles: 2
- spindle motor power: 37 kw
- spindle speed: 188 rpm
- cutting speed: 142 m / min
- tool diameter: 240 mm
- workpiece steady
- workpiece head (2 pcs.)
- hydraulic unit tank capacity: 100 l
- voltage: alternating current, 3-phase, 380V +/- 10%, 50Hz +/- 1Hz
- machine height: 2950 mm
- total weight of the milling center for crankshafts: 26 t

This equipment is located in PL