MITSUBISHI ML-3015

Listing description

processing machine specifications
machine structure: x/y precision rack & pinion - z=precision ball screw
travel drive method: x-y-z simultaneous 3 axes (z-axis height control is also

possible)
maximum workpiece size: 120.1 x 60.0
table pass height: 34.6
processing access: automatic up/down door
pallet changer: provided
x-axis stroke: 122
y-axis stroke: 61
z-axis stroke: 5.9
rapid travel speed (x,y) inches per minute: 3940/5550 simultaneous
maximum processing federate, inches per minute: 1970
positioning precision: 0.0019/20 (x,y), 0.0039/4 (z)
drive motor type: intelligent ac servo
maximum workpiece weight: 2050 lbs.
control system specifications:
cpu: 64-bit
display screen: 15" tft color lcd touch screen
hard disk: 20.0 gb
generator output control: output power, frequency, duty
generator operation control: beam on/off, laser gas charge, etc.
drive system: x,y,z simultaneous control
position detection system: encoder
minimum command input: 0.001 mm / 0.001"
program input system: usb computer link, ethernet lan

pallet changer specifications:
drive mechanism: chain
pallet change time (sec.): approximate 30
work clamps: 2 sets on y axis
pallet capacity: 2050 lbs.
applicable machine size: 3015 (5' x 10')

co2 laser specifications- 45cf-r
excitation method: 3-axis cross flow, silent discharge
maximum output power: 4500-watts
rated output power: 4500-watts
control method: power feedback
power stability: less than +/- 1 % of rated power
beam mode: low-order
beam outer diameter: 1.02
beam divergence (mrad): approximately 3.5 of less total angle
las gas composition (co2:co:n2:he): 8:4:60:28
laser gas consumption rate (liter/hour): 24 during continuous oscillation
wave length: 10.6 microns
frequency setting range: 10~3000 hz
duty range: 0~100 percent adjustable
output power adjustable range: 0~100 percent

* available with 2011 mitsubishi 11-12 pallet tower system with 1 over/under

unload for an additional cost.

This equipment is located in US