Okuma MCV-A2 CNC Bridge Mill

Listing description

Control: OSP P200M

Under Power: Yes

Width between columns: 80"
X-Axis Table Travel: 157"
Y-Axis Spindle Head Travel: 78"
Z-Axis Spindle Quill Travel: 18"
Distance from spindle to table, Min - Max: 0" - 59"
Size of table, width x length: 60" x 162"
Cutting feedrate: 0.04 to 393 IPM
Rapid traverse rate: 787 IPM
Spindle diameter: 3.94"
Spindle taper: BT 50
Spindle speed range: 30 to 4,000 RPM
Quill diameter: 8.27"
Tool stations: 72
Main motor: 30 / 25 HP
Machine height: 17 foot
Floor space: 40 ft W x 18 ft L
Machine weight: 86,900 lbs

Equipped With:

OSP P200M CNC
Complete Set of Manuals
Some Tool Holders

Comments:

6" will come off the height when the pendant if removed
New cost today: About $ 1 Mil. Delivery: 12-18 months.
The machine is under power and in GOOD TO VERY GOOD
CONDITION. It was purchased to manufacture whip stock, which is an
angular down hole tool that used to be used for offset drilling.
Mud motors, directional drilling and MWD (Measure while drilling) made
whipstock obsolete. It has been kept under power in an air-conditioned and
heated building.
Ten years ago, new owners purchased the facility. The machine has not been
used since the new owners purchased the facility. Last year Okuma come in
and powered up the machine. The batteries were dead. They were replaced,
parameters reinstalled and the machine cycled.

This equipment is located in US