Ruesch Slitting line

Listing description

YEAR: 2000
Material: Mild Steel, CR, AL, Stainless, Non-Ferrous
Material Width: 24" (26" untrimmed)
Thickness Range: 0.005" - 0.040"
Line Speed: 1000 FPM
Line Direction: Right to Left
Consisting of the following:
-Entry Coil Car:
Low Profile Design
Narrow Coil Stabilizers
Self Contained Hydraulics
Pendant Control
-Uncoiler:
Hydraulic Expansion
4 Segment Mandrel
16" - 20" Coil I.D. Range
Maximum Coil O.D.: 63"
Sliding Base
50 HP DC Motor, 500/2000 RPM, 500V
Powered Holddown Roll
Rubber Covered Roll with Banding Slot
Paper Rewinder
-Driven Pinch Roll Unit:
18" Diameter Rolls
Exit Catenary Rolls
15 HP DC Motor, 1150/2000 RPM
-Ultrasonic Detector:
-Precision Slitter Heads:
Model #146
(2) Injector Heads
Entry Catenary Rolls
Entry Side Guides
4.125" Dia. Arbors
Steel Stripper Ring Assembly
Exit Passline Rolls
Exit Catenary Rolls
60 HP DC Motor, 1500/2000 RPM, 500V
-Injector Head Shuttle Base:
-Looping Pit Threading Table:
-Ultrasonic Detector:
-Scrap Baller:
-Tension Stand:
Combination Drag and Roll Type
Entry Catenary Rolls
Entry Separator Tooling Bar
Entry Passline Roll
Entry Wiper
Drag Wipe Section with Air Bladder
3M Tension Rolls
Each Roll Driven by 30 HP DC Motor
Passline is adjustable by Laser guide. Tensioners adjust vertically
as Coil O.D. increases on Recoiler to maintain a constant Passline.
Threading Table to Recoiler
-Recoiler:
16" Dia. Drum
Manual Clamp & Expansion
Max. Coil O.D.: 63"
Hydraulic Pushoff
Overarm Separator Assembly
(Attached to Tension Stand)
Coil Clamping Arm
60 HP DC Motor, 500/2000 RPM, 500V
-Exit Coil Car:
Low Profile Design
Narrow Coil Stabilizers
Self Contained Hydraulics
Pendant Control
-Paper Unwinder:
-Slitter Tooling:
(2) Sets of Shimless Tooling
-Main Operators Control Panel:
-Hydraulic Power Unit:
-Removed and in Storage
Line only was in production for short time.

This equipment is located in US