SENCORPWHITE 2500 ULTRA 2

Listing description

FORM STATION AREA:
34" x 48"
FORM STATION CLAMPING FORCE:
35 Tons
FORM STATION PLATEN STROKE:
7" Top, 7" Bottom (Standard with Safety Stops)
FORM STATION UPPER SHUT HEIGHT:
7" + 4.0/-2.0
FORM STATION LOWER SHUT HEIGHT:
10"
FORM STATION DRIVE(S):
Servos (Top & Bottom)
FORM STATION PLUG ASSIST:
3rd-Axis Lower Servo Plug Assist
FORM STATION TOP & BOTTOM DAYLIGHT ADJUST:
Servo Actuated
FORM STATION INCLUDES:
Mold Control Temperature
TRIM PRESS AREA:
34" x 48" (rule die)
TRIM PRESS CUTTING FORCE:
130 Tons (Special kiss cut servo press with tension bars)
TRIM PRESS TOP TRIM:
Heat provision
TRIM PRESS X-PRESS DRIVE:
Motorized to ride on linear slide bearings
TRIM PRESS Y-PRESS DRIVE:
Motorized Y adjuster
TRIM PRESS ADJUSTMENT:
Top Height Adjustment
TRIM PRESS INDICATOR GAUGE:
Tonnage Indicator Gauge
TRIM PRESS TOP TRIM FEATURE:
Heated trim paten with 4 segens
TRIM PRESS BOTTOM TRIM FEATURE:
Lower trim press "Y" two-point electronic
OVEN LENGTH:
148"
OVEN ZONES:
26 Top, 26 Bottom
OVEN TYPE:
Radiant Oven
OVEN HEATING SURFACE:
Black faced quartz upper, Porcelainized steel faced lower
OVEN CONTROL:
Independently retractable
OVEN SAFETY FEATURES:
(7) IR scanners with closed loop system and auto sheet sag-detection
UNWIND STAND INCLUDES:
Low Roll Detector, Continuous Feed System, Scrap Rewind System
UNWIND STAND MAX ROLL DIAMETER:
40" Diameter Roll with roll left assembly (2000 max lbs.)
CHAIN RAILS SHEET WIDTH:
15.5" - 35.5"
CHAIN RAILS WEB FEED:
Servo driven pin chain
CHAIN RAILS INDEXING:
Servo Driven
CHAIN RAILS INDEXING PREHEAT:
Edge preheat sheet guide 48"
CHAIN RAILS INDEXING RAIL ADJUSTMENTS:
(4) Point motorized rails adjusters
CHAIN RAILS INDEXING SENSORS:
Temperature sensors on both rails
CHAIN RAILS INDEXING SHEETLINE DISTANCE TO THE FLOOR:
61"
CHAIN RAILS INDEXING ELECTRICAL REQUIREMENTS:
480/3/60
CHAIN RAILS INDEXING EQUIPPED WITH:
Auto Chain Tensions, Auto Bow Rail Adjust with Readout on HMI Screen
PART OFF-LOAD SYSTEM STACKER:
Servo Upstack with Push Off and Down Stack
PART OFF-LOAD SYSTEM INCLUDES:
Purge Button on Stacker Conveyor (10' Conveyor)
QUICK TOOL CHANGE SYSTEM CONTROLLER:
Siemens Controller System, S7-1500
QUICK TOOL CHANGE SYSTEM INCLUDES:
Form Tool Directional Valve, Vacuum Bleed Valve, Manual Quick Change Tool Rails, Tool Hoist (2,000 Lbs)

This equipment is located in US