USED HAAS DT-1 CNC DRILLING/TAPPING MACHINING CENTER NEW: 2015

Listing description

TABLE LENGTH 26"
TABLE WIDTH 15"
X-AXIS TRAVEL 20"
Y-AXIS TRAVEL 16"
Z-AXIS TRAVEL 15.5"
SPINDLE SPEED 20,000 RPM
SPINDLE MOTOR 15 hp
SPINDLE TAPER BT 30
TOOL CAPACITY (ATC) 20
RAPID TRAVERSE - X/Y AXIS 2,400 in/min.
RAPID TRAVERSE - Z-AXIS 2,400 in/min.

20,000 RPM OPTIONAL SPINDLE
THROUGH SPINDLE COOLANT (300 PSI) - TO BE USED AT SPEEDS UNDER 12,000 RPM
RENISHAW WIRELESS INTUITIVE PROBING SYSTEM (WIPS)
20 POSITION SIDE MOUNT TOOL CHANGER
DUAL AUGERS FOR CHIP REMOVAL
CHIP CONVEYOR WITH NIGH-NECK DISCHARGE
PROGRAMMABLE COOLANT
HIGH-SPEED MACHINING (WITH LOOK-AHEAD)
COORDINATE ROTATION & SCALING
M19 SPINDLE ORIENTATION
ADVANCED TOOL MANAGEMENT
SPINDLE LOAD MONITOR
SPINDLE ORIENTATION
RIGID TAPPING
QUICK CODE
MACROS
750 MB EXPANDED MEMORY
AIR GUN
USB PORT
* NEW SPINDLE INSTALLED 5/2019 - VERY LITTLE USE AFTER INSTALL
HOURS OF USE AS OF 4/8/2022:
* SERVO TIME: 3,670 HOURS
* MOTION TIME: 303 HOURS
* SPINDLE TIME: 292 HOURS
*** THIS UNIT WAS DEMONSTRATION MACHINE FOR HAAS CORP 5/2015 - 11/2016
** REPLACEMENT COST NEW FOR THIS UNIT AS EQUIPPED ABOVE: $94,000
** MACHINE IS IN PLANT, UNDER POWER. AVAILABLE IMMEDIATELY

This equipment is located in US