Welding Alloys Hot Wire TIG Cladding System

Listing description

We are selling this used Welding Alloys Hot Wire TIG cladding system
Package includes a 3 ton welding positioner interfaced into the system That has been used not in the frame if required as a horizontal positioner or in the frame used as a tilting positioner
Miller Maxstar 700 water cooled TIG GTAW welding power supply
Miller Dynasty 210 AC/DC hot wire TIG power source or can be used as a standard.
Lenze running software
Column and Boom working range 2000mm x 3000mm on swivel base
Can be seen on site working
New CPU and had the software upgraded
Lenz C3200 PLC/Motion controller,Lenze P300 10” touch screen
Pre heat unit and selection of pads
The rotator has its own control for rotation and tilt. The C3200 outputs signals to control rotation but not tilt which is controlled with its own independent pendant
Flat welding, for cladding the surface of a disk or filling a ring groove with the table set horizontally. Cylinder welding, for cladding the surface of a cylinder with the table tilted vertically.

Sold fully serviced with warranty
Can be sold AS IS with no warranty POA

This equipment is located in GB