Wheelabrator WS210A

Listing description

WHEELABRATOR (MADE IN USA)
SHOT BLAST MACHINE

MODEL: WS210A SPINNER HANGER TYPE
WITH INTEGRATED DUST COLLECTOR SYSTEM
(SEE PHOTOS)
NEW: 1995

Hanger Machine is designed to handle the cleaning
and surface preparation of cavernous and odd shaped work
that cannot be adapted to a table or Tumblast™ Machine.
Parts are loaded onto a hanger and rotated during the blast
cycle for multiple angles cleaning. There is no component
contact during blasting, so fragile and thin walled parts can
be cleaned without damage."

Preliminary Specifications

Two (2) 13.5" diameter TruBlast® wheel assemblies,
direct driven with 10 h.p., 3600 rpm, NEMA T-frame motors.
1/2" thick Long-Lyfe® liners, in line with wheel blast pattern,
with 1/4" thick rubber throughout remainder of cabinet and on work door.
Manganese steel work hook mounted to a 2" diameter spinner shaft which is
protected by a fitted manganese sleeve and attached to an oscillating work trolley.
Gear motor driven chain and sprocket arrangement produces a work piece
rotation of approximately 18 rpm.
Work trolley is pneumatically oscillated on a 6" I-beam while work is rotated
in the blast area.
Cabinet roof spinner shaft slot is sealed with nylon brushes and rubber slot seals.
Abrasive media is returned to the belt and bucket elevator by a gearmotor
driven 6" diameter screw conveyor.
Airwash separator with counterweighted swinging baffle for maintaining the
proper abrasive curtain.
Pneumatically operated abrasive control valves for positive control of abrasive flow.
Pneumatic door lock with timed operation to prevent opening door when abrasive
is flowing to wheels.
Limit switch on work door to prevent wheel from starting when door is open.
Cleaning envelope: 30" diameter x 42" high.
Abrasive charge of approximately 2,000 pounds.
Maximum load per work hook of 2,000 pounds.

Electrical:

Two (2) 10 h.p., 3600 rpm, NEMA T-frame wheel motor.
One (1) 1/2 h.p., 1800 rpm, screw conveyor gearmotor.
One (1) 1/2 h.p., 1800 rpm, spinner hook gearmotor.
One (1) 1 1/2 h.p., 1800 rpm, elevator drive gearmotor.
Control panel equipped with pushbuttons and pilot lights,
emergency stop button and mainline disconnect.
Machine is Presently Wired for 3/60/460 Volts

Applications:

Idea for diecast deflashing.
Scale and rust removal.
Peening.
Profiling.
Surface finishing.
Dimensions:
Machine : 140” long x 92” wide x 145” high
Part A: 180” long x 104” wide x 42” high
Part B: 196” long x 37” wide x 36” high

Approx. Weight: 15,000 Lbs.

This equipment is located in US