6″ Nrm Reconditioned 30:1 Extruder

Listing description

Description

6” NRM extruders (we have 4) this one listed here with the photos runs now daily PE at about 1,500 pounds/hr. Runs perfect but could probably use a screw rebuild.
These 6” NRMs that we have in stock are idle and disassembled for a future rebuild upon getting an order. We have THREE 6” NRMs here as rebuild candidates all quoted the same but we can make one water cooled and/or NON-vented if needed but the price will change and be a little higher.
We rebuild to our customer needs. – you can buy this one now as is – or we can recondition it….etc.

One (1) Reconditioned 6″ NRM Extruder, with approximate 43″ centerline height, gearbox having new berings (less thrust) and seals with cooling unit, heat exchanger, pump and motor, 30:1 L/D & 8 zone barrel, rewired cast aluminum heaters, air cooled NON-Vented barrel, honed barrel, rebuilt PE Screw, rebuilt 400 HP AC motor with AC drive control in panel. Rewored 12 zone control panel with newer interior electronics & Cal 9900 and solid state iinstruments, with feed hopper and diverter valve. We have it all… we do it all…. call for a customized quote….. 516 766 3222 office

This equipment is located in US