Fully Refurbished Demag Ergotech Concept 1500-610

Listing description

Viewing: Available to inspect by appointment
Condition: Refurbished with guarantee
Clamp Force (t): 150
Screw Diameter (mm): 45
Max Shot Weight (PS) (g): 290
Control System: NC4
Lead Time: Immediate
In Production: Yes

This Demag Ergotech Concept 1500-610 injection moulding machine. This machine has a 45mm plasticising unit which gives a maximum shot weight of 290 (PS) (g). Comes with an NC4 Controller with a centre click wheel, this is the later version of the NC4 and is fully supported by Sumitomo Demag. With large tie bar spacing (relative to the clamp) of 500mm, it is a very good trader moulder machine. The toggle lock of this machine means a slight energy efficient advantage over direct lock machines of a similar age. Available for full inspection at our workshop.
This variant of machine has sold many units over the years, and parts are readily available on the used market, as well as from the manufacturer. Many third-party engineers are also familiar with the design which increases the longevity of the machines life.

Refurbished machines undergo a comprehensive test procedure during which every function of the machine is tested and if necessary repaired. A production run of at least 5000 fault free cycles prior to sign off ensures trouble free operation once delivered. Machines are ultra clean and cosmetically as good as we can get them. We guarantee our refurbs are delivered fault free and leak free.

This equipment is located in GB