Ganesh TY5040CNC

Listing description

Machine Type: CNC Lathes

Year: 2011

Manufacturer: Ganesh

Model: TY5040CNC

Control: Fagor 8055i-TC

Condition: Good

Capacity:
Swing over the bed: 52"
Swing over Cross Slide: 36.20"
Center Height: 25.60"
Bed width of ways: 35.40"
Spindle
Spindle Bore: 10.04"
Spinde Nose: A2-15
Spindle Motor (Peak / 30 minute): 40 HP / 30 HP
Spinde Speed Range (3-Gear Ranges): 5-550 RPM
Spindle Bearing Type: Taper Roller Bearings
Spindle Weight capacity (Chuck only): 3,300 lbs
Spindle Weight capacity (Chuck and Steady Rest): 6,600 lbs
Rear Chuck Swing Capacity: 25"
Axis Travel:
Rapid Traverse Feedrate, X & Z-Axis: 394 IPM
X-Axis Cross slide travel: 27.5"
Z-Axis Longitudinal travel: 43.25"
X-Axis Servo motor: 2.6 HP
Z-Axis Servo motor: 5.0 HP
Ball Screw Diameter (X Axis): 1.5"
Ball Screw Diameter (Z Axis): 2.5"
Cross Slide Dimensions: 39.4" x 11.40"
General:
Overall machine length: 157.50"
Overall machine width: 86.60"
Overall machine height: 85.40"
Shipping dimensions: 165" L, 90" W, 90" H
Machine weight: 16,515 lbs
Shipping weight: 17,600 Ibs
Coolant capacity: 40 gallons
Equipped With:
FAGOR 8055i-TC control
On Board Programming Software
50" Chuck - 4 jaw
25" Secondary Chuck - 4 Jaw
Chip Conveyor
Comments:
Purchased new August 2012
The price of this machine in 2015 was $206,000
It is still in service at present time and is used as needed
3 Gear Ranges for High Torque
4-Position Programmable Toolpost
Full CNC Control & Full Manual Control with Teach-Mode
Full CNC Control & Full Manual Control with Teach-Mode
4-Way programmable toolpost
Spindle Speed Ranges: S1: 5-110rpm, S2: 12-50rpm, S3: 27-550rpm
Electrical Requirements - 380 -440vac, 20kw, 60-hz, 3-PH, 42A
Ideal for Oil-Pipe Threading and Large Rings

This equipment is located in US