Harig E-Z SURF

Listing description

6" x 18" harig "E-z surf" surface grinder

Model: ez-surf new: 1997

Specifications:
Max. Grinding capacity ............................... 6" x 18"
Max. Longitudinal table travel, hydraulic ............ 20"
Max. Crossfeed travel, automatic ..................... 6.75"
Dist. From spindle center to table ................... 12"
Variable table speed, hydraulic ...................... 36" ipm to 70' fpm
Minimum feed increment ............................... 0.0001"
Rapid traverse rate .................................. 100" ipm
Minimum feed increment ............................... 0.0001"
Standard grinding wheel .............................. 8"Dia. X 1- 1/4" x 1- 1/4"B
Approx. Weight ....................................... 2,250 lbs


Features:
3-axis automatic operation
"Ez-surf" pc based programmable control (cross & vertical axes, y/z axes).
2-axes linear & circular interpolation.
Mdi- setup-teach-program & edit.
Profile grind & profile dress modes
(create your own radius& taper forms for grinding as well as forming your wheel).
On-screen graphic display of wheel path prior to cutting.
Conversational mdi for form & step grinding.
Slot & form creep feed grinding, simultaneous
Two-axis linear& circular interpolation.
Absolute & incremental operation.
Dwell in mdi or end of stroke.
Jog.
Wheel library display.
Rs-232 port & disk drive.
Electronic handweels on y & z axes ...
Ballscrews on y & z axes
Manual, semi-automatic or fully automatic
Hydraulic table traverse
Cast iron construction including base

Accessories:
Set up for coolant with coolant tank & pump
6" x 18" fine-division permanent magnetic chuck
1.5 h.P./3/60/208-230-460 volt spindle motor
Machine is presently wired for 3/60/460 volts

This equipment is located in US