Holzher 1329 Premium Edgebander

Listing description

DESCRIPTION

Holzher 1329 Premium Edgebander Loaded, Year: 2015
Edging thickness in coil: .4 to 3 mm
Edging thickness in strip: 8 mm (15 mm possible with tool change at multifunctional trimming unit)
Edge strip length: 13.78" minimum to unlimited
Panel thickness: 8 to 60 mm
Minimum workpiece width: 60 mm
Minimum workpiece length: 160 mm
Feed speed: Variable from 32 to 59 FPM
Servo controlled infeed fence
Pre-milling station with (2) 2 KW 12,000 RPM motors, one counter clockwise and one clockwise
rotation (max stock removal - 3mm)
Edge feed magazine for fully automatic feed of coils and strips from .3 to 15 mm
Automatic guillotine for coiled material up to 3 mm
Gluing station: Glu-Jet Hybrid Technology - glue application through a nozzle applicator for glue cartridges
or all commercial granulated hot melts (granulate hopper required but not included)
Automatic rinse function directly from control panel
Heat up time: Approximately 3 minutes
Motorized pressure unit: 1-axis servo motor for the adjustment of the edge thickness, large driven roller
with (2) additional idle rollers
End trim unit: (2) .45 KW 9,000 RPM motors, mounted with uni-point axis enabling quick change from
10 degrees bevel trimming to flush trimming through pneumatic changeover system (PCS)
Top/bottom trimming unit: (2) .65 KW 12,000 RPM motors, with (4) servo motor adjustments for flush,
radius and chamfer cuts (servos adjust cutter motor and sensing shoes, pneumatic in and out movement of unit carriage)
Corner rounding/trimming unit: (2) .4 KW motors, for top/bottom trimming and rounding of corners - radius, chamfer.
Can be programmed to be used as a second top/bottom trim unit. 4 servo motors for control of height adjustment and
to adjust entire unit
Feed speeds vary when using corner rounding/trimming unit depending on material thickness
Profile scraping unit: With 3 mm radius tooling, motorized adjustment of the horizontal copy wheels with (4) servos
Finish scraper: Flat knives scraping along board/banding joint, with pneumatic engage/disengage via controller –
includes 2 blow nozzles, 2 insert knives
Top and bottom buffing unit with (2) .09 KW 1,440 RPM motors
Air requirements: 6 bars
Machine dimensions: 18'3" long x 4'3" wide x 5'6" tall
Voltage: 230 Volts, 3 Phase

This equipment is located in CA