KRONES Variopack packer with shrink wrapper

Listing description

KRONES Variopack packer with shrink wrapper

Variopack packer: ca. 3600 kg
Shrink wrapper: ca. 2500 kg

Technical data:

shrink wrapper
Type: 72
Year of construction: 2004
Floor load: (≈ 4 x 6250) N
Alignment angle: ± 1 °
Volume level:
0 <82 dB (Lam, DIN 45635-T1-1-KI2)
Operating voltage: 230/400 V
Control voltage: 24V / DC
Main fuse: max. 125 A
Rated current: 100 A
Rated power: 69 KVA
Frequency: 50 Hz
Circuit diagram no. 2004.ST72-45.902

Variopack packer

Type: Variopack Compact TFS 30

Electrical:
Voltage: 230/400 V ± 5%
Frequency: 50Hz ± 2%
Power rating: ~ 16 KVA
-Wirkleistung: ~ 16 KW

Pneumatic:
Overpressure: min. 5 bar / max. 6 bar
Dew point: -5 ° C
Filter: 40 micro
Air consumption: max. 6.7 Nm3 / h

Floor load: ~ 6 x 5000 N + 2 x 6500 N + 2 x 1500 N
Alignment angle: ± 1 °
Volume level: = <85 dB

The workplace-related emission value is between 75 and 85 dB (A) + - 2 dB measurement tolerance, measured according to DIN EN 11204 accuracy class 2.
Note: This value may increase or decrease depending on the container / container to be processed and the machine performance / building acoustics.

The safety devices comply with European law and the generally accepted rules of technology.

Application notes:

Processing range:

Container:
Type: cans, glass, PET, packs
Diameter: 50-110 mm
Height: 70-360 mm

Pack sizes:
Transverse to the direction: 240-450 mm
In running direction: 110-350 mm

Carton blanks:
Transverse to the direction: 185-610 mm
In running direction: 120-510 mm

Foil:
Thickness: 40-80 ± 5 micrometer
Roll diameter: -500 mm
Core diameter: 76 + 3 / -2 mm
Width: 700 mm
Width (two lanes): 2x340 = 680 mm
Edge profile (deviation): ± 1.5 mm

Carton Specification:
Fine wave (B wave), single-wave
Standard quality VDW 1.2 or 1.3
Buzzer of basis weights 250-300 g / m2
Wave height 2.2-3.0 mm, wave pitch 5.5-6.5 mm

Interior and exterior ceilings should be 'kraftliner'.

Permissible deflection of the box:
Max. Deflection x = 2.0% of the blank length or blank width.
The permissible tolerances with regard to the geometric dimensions must be less than 0.5%!

Execution of beer grooves:
The beer grooves must be so pronounced that the restoring forces do not re-set the box after kinking. On the other hand, the bending groove must not be so pronounced that the cardboard collapses when kinking.

Execution of the punched out:
The cutouts must go over the inner bending groove, so that the lid can be easily bent.

This equipment is located in DE