Takumi V10

Listing description

x: 39.37
y 26
z 24.01
Travels 1,000 x 660 x 610 mm)
24 station
12,000 RPM
40 taper
table 41.34 x 25.59 in (1,050 x 650 mm) with a capacity of 2,204.62 lbs (1,000 kg)
machine weight 14,770 lbs (6,700 kg)

Specifications
Travels X-Axis………………….…………………………………………………………….……………………....39.37″
Y-Axis……………..…………………………………………………………………………………………….…………….26″
Z-Axis………….………………………………………………………………………….................................24.01″
Distance From Spindle Nose To Table…………………………………………………………..5.91″-29.92″
Distance From Spindle Nose To Z-Axis Guide Ways……………………………………….……….27.56″
Table Dimensions…………………………………………….………………………………………41.34″ x 25.59″
Maximum Load………………………………………………………………………………………………2204.62 lbs
T-Slot (Width x pitchx number)…………………………………..……………..…..0.708″ x 9.93″ x 0.19″
Spindle Type…………………………………….………………………………………………..………………………Belt
Spindle Speed…………………………………………………………………………………………………10 000 rpm
Spindle Torque Peaks………………………………………………………………………….…………….70.8 ft/lb
Motor Power (Cont./30min)………………………………………………….…………….………10.1/20.1 HP
Coolant Thru Spindle………………………………………………………………………………………………30 bar
Spindle Taper………………………………………………………………………………………….…………….CAT 40
Feed Rate Rapid Traverse (X/Y/Z)…………………………………………..……….……....945 x 945 x 787
ipm Cutting Feed Rate…………………………………………………………………………………….….315 ipm
Power (X/Y/Z)……………………………………………………………………………………….…………...4/4/4 HP
ATC Type………………………………………………………………………………………………..……….Swing Arm
Magazine Capacity……………………………………………………………………..……...24 Tools Maximum
Tool Diameter / Next Pocket Empty………...………………..…………………………..……..3.15″/5.91″
Maximum Tool Length……………………………………………………………………………………….….11.81″
Maximum Tool Weight…………………………………………………….……………………………….……15.43″
Tool Shank……………………………………………………………………………………..……………………..CAT 40
Pneumatic Pressure …………………………………………………………………...…..5 CFM @ 85-115 psi
Electrical Power Consumation…………………………………..………………………………………….35 KVA
Machine Net Weight ……………………………………………………………………….………………14 770 Lbs
Operating Dimensions…………………………………………………….……248.03″ x 165.35″ x 124.02″

Equipped With
Mitsubishi Control
Half of the ATC filled with Tooling
Chip Conveyor
Transformer

This equipment is located in CA