Used DMT BOPP EXTRUDER

Listing description

Manufacturer: DMT
Model: BOPP Coextrusion Line
Year: 2002
Number of layers: 3
Material: BOPP
Output: 2800 kg/h
Width (mm): 6800
Extruder 1 Description: Manufacturer: Davis Standard, co-extruders with max output 150 kg/hr and 200 kg/h DC drive – 02 Co extruder motors Stand by L/D 30:1 Included with double filters with surface area: 0.81m2/unit
Extruder 2 Description: TWIN SCREW EXTRUDER, TM 133 MW, 2800 kg/h, Melt pump Manufacturer: Maag AC drive Main filter: L.666 Surface area: 6.36 m2
Extruder 3 Description: Co extruders, Manufacturer: Davis Standard, 2 co-extruders with max output 150 kg/hr and 200 kg/h DC drive – 02 Co extruder motors Stand by L/D 30:1 Included with double filters with surface area: 0.81m2/unit
MDO description: 14 pre-heating rolls – Electrical heaters; 4 stretching rolls – Circulating oil; 2 annealing rolls – Electrical heaters; 5 nip rolls; AC drive; Stretching ratio 1:1 – 1:6
TDO description: Chain and chain track System; Heating system: circulating air via individual heating system / zone (Electrical heater, motors, fans, sensor, etc) Edge guide system at inlet
Pull roll unit: Cromed Rolls chilled by water; Edge trim on-line recycling unit; 2 corona treatment stations (up and down – Double treated) AC drive Thickness Gauge X-ray: – Measurement range: 5 – 100 micron
Rewinder description: Turret Automatic change
Slitter: Slitter and Rewinder: – Atlas Slitter and Rewinder 6.8 m (1000 m/min – CW964) 10 «Stations»
Additional informations: Max mechanical speed: 280 m/min
Edge recycling system
Pneumatic conveying system
Cyclone to separate resin and conveying air Metal separator
Mixing hopper
Suction conveying for Co-Extruder
Edge trim recycling
Edge trim grinder
Conveying fans

This equipment is located in ES