Used NuAire NU-2700 IR Autoflow CO2, Water-Jacket Incubator

Listing description

Configuration:
• Type: Over-Under
• Exterior: 75" H X 25½" W X 29 1/8" D; (1905 mm X 648 mm X 740 mm)
• Internal: 25½" H X 21½" W X 21" D; (647 mm X 546 mm X 533 mm)
• Base Footprint Width: 22¾ (578 mm)
• Base Footprint Depth (Front-to-Back): 20¼ in (514 mm)
• Volume (Interior): 6.64 cu.ft. (188 L)
• Input Voltage: 115 VAC
• CO2 Input Pressure: 20 psig (1.4 bar)
• (1) Drip Tray
• (1) Operating Manual

Features:
Digital Infrared Gas Sensor
Microcomputer Controls
HEPA Filtration System
The NuAire IR AutoFlow Incubators are the most advanced tools for the modern laboratory professional in the most demanding environment. The IR AutoFlow has been designed for laboratory work which requires the precision of a microcomputer based Control system that is programmable for precise control of chamber temperature and CO2, the added stability and efficiency of infrared CO2 sensing, the dependability of sophisticated memory and back-up systems, and the advantage of add-on expansion built into the system.

Temperature Control System
Range 5 degrees C above ambient to +55 degrees C
Uniformity ±0.2 degrees C at 37 degrees C
Sensitivity ±0.0125 degrees C
Display Bright Green LED Digital Display
Selectable from the Control Panel
Resolution: 0.01 degrees C
CO2 Gas Control System
Accuracy ±0.1 percent
Uniformity ±0.1 percent
Range zero to 20 percent
CO2 Recovery 5% plus or minus 0.2& within 2 minutes
Calibration Auto Zero (NO tools/NO cover removal)
Utility Connections/Installation
CO2 Gas Connection 1/4-inch tubing connection
CO2 Gas Input Pressure 20 PSIG (1.4 BAR) input Pressure
Two Stage Gas Regulator Required
Water Fill Port Located on front of chamber with 1/4" NPT opening for 3/8" tubing connection (nipple supplied)
Over Fill Port Located on front of chamber near water fill port
Drain Port Drain valve located on bottom front for total drainage

This equipment is located in US