Used Rosenquist Model EG-1000-H Inclined Radio Frequency Edge Gluer

Listing description

The Rosenquist Model EG-1000-H is a feed thru, high quality, high production, radio frequency edge laminating and assembly press
The press is mounted at a 40-degree angle for ease of loading
The top platen will open 70 degrees from the bottom platen for ease of access to the press area
Gluing Capacity: 120" long x 48" wide x 2.5" thick
Self-containedRosenquist 20 KW generatorwill efficiently cure approximately 2,000 square inches of glue line per minute of cure time
In-Feed Lay-up Table 132" Long x 53" Wide, will tilt to Align with the Press or Lay Flat on a Horizontal Plane
Out-Feed Table 126" Long x 48" Wide with a Tilt Down Device Similar to the In-Feed
Side Pressure: 20 Individual Hydraulic Cylinder 1.5" Bore x 24" Stroke
Top Pressure: 5 Hydraulic Cylinders 2" Bore
Hydraulic Pump Unit with 15HP Motor Powers a 20 GPM Pump
Pre-Clamping Feature Allowing the Operator to Apply Reduced Pressure to the Product While the Top Platen is in the Open Position

Smart Cure will Automatically End the Cure Cycle Once the Adhesive is Set

Automatic Power Control Eliminates the Need to Adjust Power Control Manually

Programmable Cylinder Selection: The Control System is Equipped with a Interface Module that will Allow the Operator to Select Which Edge Pressure Cylinders will be Active to Clamp the Next Door from the Operators Control Panel

Currently Wired for 480 Volt Power. Incoming Amps: 121

Upgrades Included:

Light Curtain with Safety Relay across the front of the machine

Redundant Plate Contactor

High / Low Power

Stack Light with Alarm

New Touch Screen

This equipment is located in US