Acra 19”x15”x13”

Listing description

Mitsubishi 64M Controller
Fully Traveling Column
Low Inertia Spindle
Spindle Speeds 60-10,000 RPM
Rigid Tapping 3,000 RPM
180 Degree Swing Table Design
APC Time (5 Sec.)
High Repeatability Accuracy
Minimized Floor Space
Specifications

Spindle

Spindle Taper Nose: BT-30
Spindle Pull Stud: 45 Degree
Spindle Speeds: 60 ~ 10,000 RPM
Bearing Contact Angle: 15 Degree
Bearing Type & Class: 7009 P5
Belt Type: 5GT-960-30
Spindle Dia.: 1.77”
Spindle Shaft Hardness: HRC 60 Degree +/- 2
Clamping Force: 3~3.5 KN
Driver

Spindle Motor: 5/3 HP
X Drive Motor: 1.3 HP
Y Drive Motor: 1.3 HP
Z Drive Motor: 1.3 HP
Working Area

X Axis Travel: 19.68”
Y Axis Travel: 15.74”
Z Axis Travel: 13.77”
Spindle Center to Column: 17.7”
Spindle End of Table: 7”~18.8”
Table Size (L x W): 23.6” x 15.7”
T-Slot Width x Number: .55 x 3
Table Load: 550 Lbs. x 2
APC: STD
Pallet Change Time: 5 seconds
Axes

X Ballscrew Dims: R32x 12,C3 Class
Y Ballscrew Dims: R32x 12,C3 Class
Z Ballscrew Dims: R32x 10,C3 Class
X/Y/Z Rapid Traverse: 36/36/48 m/min
Two/One Way Positioning Accuracy: 0.022/0.016 mm
Two/One Way Repeatability Accuracy: 0.012/0.006 mm
X Liner Motion Size: 1.37”
Y Liner Motion Size: 1.37”
Z Liner Motion Size: 1.18”
ATC

Magazine Capacity: 20+1
Tool Weight: 6.6 Lbs.
Tool Length: 7.87”
Tool Diameter: 2.75”
Tool Change Time (T-T): 0.8 Seconds
Tool Change Time (C-C): 1.8 Seconds

This equipment is located in US